Door Operators

Residential

The MK-IVR swing door operator is ideal for interior and exterior doors that latch when
closed, and will automate all exterior swing doors up to 4' in width, in an inswing or
outswing configuration. This header mount door operator consists of three modular components for easy installation and service: a microprocessor based motor & accessory control board, a drive assembly consisting of a 3" diameter DC motor with a permanently lubricated & sealed gear box and a wireless control receiver for easy and convenient remote button actuation. This system will unlock, power-open, hold open, power close and relock the door to be automated. It will also allow the door normal manual operation. This operator is equipped with the accessory module which provides a terminal strip for control and power supply for an electric lockstrike, and contacts for security system integration. Factory programmed microprocessor chips are available for special needs. This operator complies with ADA/BHMA low-energy door operator requirements and also has been tested to exceed 1 million full-load cycles.

Commercial

The MK-V swing door operator is ideal for retrofit or new construction,
and will automate all swing doors up to 4' in width. The header-mount
door operator features three modular components. A microprocessor
based motor and accessory control board, a drive assembly consisting
of a 3" DC motor and a permanently lubricated and sealed gear box
and a cast-iron hydraulic door closer. The unit can also operate simply
as a door closer when power is turned off, or if used as an On Demand
door operator with wall switches. An RF receiver is standard for wireless
push-button operation. This operator is equipped with an accessory
module which provides a terminal bus bar, control and power supply for
an electric lockstrike or magnetic lock. Also provided are card reader or
keypad trigger inputs as well. For full automatic operation, contacts and
sensor power supply are available.

Door Operator Features